NOW YOU HAVE AN OPPORTUNITY TO CHANGE YOUR OLD CHERRY MASTER PCB TO DOGS & DIAMONDS 
VERSION 1 : PAYOUT PERCENTAGE ADJUSTABLE 30%, 40%, 45%, 50%, 55%, 60%, 65% & 70% (or you can use levels 5, 6, 7, 8, 9, 10, 11 & 13 instead of a percentage.VALUES FOR 888 & ALL FRUITS BONUS = 500, 1000, 2000, 3000, 4000, 6000, 8000 & 9000
VERSION 2 : PAYOUT PERCENTAGE ADJUSTABLE 55%, 60%, 65%, 70%, 75%, 80%, 85% & 90% (or you can use levels 1, 2, 3, 4, 5, 6, 7 & 8 instead of a percentage.VALUES FOR 888 & ALL FRUITS BONUS = 500, 1000, 2000, 3000, 4000, 6000, 8000 & 9000
VERSION 3 : PAYOUT PERCENTAGE ADJUSTABLE 30%, 40%, 45%, 50%, 55%, 60%, 65% & 70% (or you can use levels 5, 6, 7, 8, 9, 10, 11 & 13 instead of a percentage.VALUES FOR 888 & ALL FRUITS BONUS = 10000, 12000, 15000, 17000, 20000, 23000, 25000, & 30000
VERSION 4 : PAYOUT PERCENTAGE ADJUSTABLE 55%, 60%, 65%, 70%, 75%, 80%, 85% & 90% (or you can use levels 1, 2, 3, 4, 5, 6, 7 & 8 instead of a percentage.VALUES FOR 888 & ALL FRUITS BONUS = 10000, 12000, 15000, 17000, 20000, 23000, 25000, & 30000
Max of ALL Fruit Bonus, Base of All Fruit Bonus, Max of 888 Bonus, and Base of 888 Bonus can be adjusted individually in Confirm screen, instructions are shown on Confirm screen. If present Bonus Point is lower than newly changed Base, Bonus Point will be changed to new Base immediately. If present Bonus Point is higher than newly changed Base, new Base will be used only after Bonus hit. If present Bonus Point is higher than newly changed Max Bonus Point will be changed to new Max immediately.
Caution: Always set Max equal or higher than Base.
Kit installs in minutes! No soldering or special skills needed. No special wiring or switches are needed!
Please note: if your board is with 1 narrow EPROM on the place U84 and on the U79 is a blank place, on this case you needs request a kit set for U84 narrow PCB .
kit set as shown on below photo with yellow contour.
From your board needs remove and replace the following chips:
a) 7 EPROMs 1-2-3-4-5-6-7 as shown in the picture above in a yellow contour.
b) The 2 chips U81 & U66 (on top left side) and replace it with our 2 wired chips.
c) The 2 chips U79 & U84 (on some boards are label with C15 & C16 ) and add there our small sub-pcb.
Be sure all the chips are with sockets, if not, then you need a technician guy for unsolder the chips.
Updating the software on your board is easy! Simply lift out the old EPROM, reinsert the new EPROM (divot in new EPROM must face same direction as old EPROM removed) and then your board is ready to be plugged in and turned on!
YOU CAN USE THE ABOVE KIT IF YOUR PCB HAVE 2 CHIPS ON U79 & U84 WITH 2 PROMS AS SHOW ON BELOW PHOTO